System Connections
System connections consist of two input signal and two output
signal connections to the SM2. The two cables attached to the end of the
SM2 are used to provide the input connections from a receiver or
gyro while the two pin connectors on the end of the SM2 are outputs to be
connected to servos. The servos plug into the SM2 in the same orientation as the receiver cables.
With the servo connectors facing away from you, and the DRC-Bus connectors
pointing up, connect the servos so that the negative battery wire is
on the left, and the signal wire is on the right. Use of the DRC-Bus is optional. If used, the DRC-Bus can provide
real-time telemetry to the DRC data recorder.
2-Channel Standard Mixer SM2
Copyright © 2009 Desert RC